Skip to content
Back to the blog

Material guide

PETG vs. ASA for Outdoor 3D Prints

Choose filament for outdoor parts based on sun, heat, and load. Use this checklist before quoting a mount, clip, or sign.

Start with PETG for an outdoor part that spends most of its time in shade, such as a clip under a porch. For a sign or mount that sits in direct sunlight year-round, choose ASA for its UV resistance. If the part carries a sustained load or gets hot, check the design and the specific filament before choosing either one.

Check where the part will live

  • Sun: Say whether the part gets afternoon sun, intermittent sun, or year-round shade.
  • Heat: Describe nearby heat sources and enclosed spaces. A dark part in direct sun can run hotter than the surrounding air.
  • Load: Note where fasteners bear on the part and what it will hold. Check whether the load pulls layers apart or mainly presses them together.

Prototype the feature that matters

Print a short section of the clip, fastener hole, or mating edge first. Measure it after cooling, then try the fit against the actual hardware. Use the same material and print orientation you plan to use for the final part.

Use the printable fit-test gauge

Get a quote for your part

PETG and ASA are both in the online configurator, and the quote shows the price of each for your file. For a loaded mount or a tight fit, contact the shop with the model and expected exposure before you order.

Further reading from Prusa on PETG and ASA.